Highway Toll Stations Autoamtic Parking Barrier Gate with Double Limit Switch 2 Fence Arm

Type

Model: GAT-P7

Operation time

3s, 4s, 6s Customized

Arm Type

Straight Arm: Max 6 meters, Size 45×100mm and 45*80 mm aluminum alloy
Fence Arm: Two or three fence arm, Max 4.5 meters, aluminum alloy
Folding Arm: 90 or 180 degree folding arm, max 5 meters, aluminum alloy

Material

Galvanized sheet or Cold roll sheets, 2mm thickness, can be heavy duty
Coated with epoxy paint for weatherproof protection

Size

350*280*1070mm

Spring And Bearing

Heat Treatment: more durable, more than 5 million times through operation testing

Rating Power

80W

Rating Voltage

AC 220V/110V±10%, 50/60HZ

Remote Control Distance

less than 50 meters

Packing Size

420*360*1060mm , strong carton case with cushion
inside with air bubble film for protection,outside with a crate package

G.W

65 KG

Delivery

By Sea: big order(more than 100 sets), Cheap, suggested
If urgent, can be delivery by Airplane or express

Payment

Sample: full payment
Order: usually 30%-40% advance deposite, balance before shipment

Advantages

1. quick delivery time, 3-5 days for 50 sets after received advance deposite
2. 9 years OEM/ODM experience
3. quick response for handling problems

Application

Suitable for indoor as well as outdoor parking area at airport, shopping mall,
warehouse,hotel, factories, condominium, car rental companies, etc. It can
also be customized to beused together with any auto-pay ticketing parking
or access control system

Common problem

Analysis

Solution

When motor running, the boom does not work.

1. the key-pin of main shaft of motor drops

2.bending-arm of mechanism part breaks-down

1. open the motor and refix the key-pin

2. dismount the mechanism part and replace the bending-arm

The arm vibrates during moving-down or reaching its horizontal position

1. Non-balance caused by weak spring tension;

2. Arm’s screws are loose;

3. The case is not fixed well.

1. replace the spring according to the Matching table of starndard spring or change hanging-hole’s position; or adjust the connection screw-rod of the spring to correct position;

2. fasten arm’s screws;

3. fasten the botls of the case;

The arm stops during movement.

1.wrong adjustment of limit switches
2.too much spring tension

1.check the connection of limit switches and correct;
(see connection drawing fordetails)

2.replace the spring or change hanging-hole’s position;

Anti-collision fails

ground sensor or IR wire damages or wrong connection

Replace ground sensor or Irparts, correct the connection carefully according to the drawing;

The arm could not reach right position.

Wrong adjustment of limit switches

place the arm in horizontal orveritical position, adjust the photo-barrierto the middle of photoelectric switches till lightis on. Red light for reaching horizontal position; green light is for reaching vertical position;